Windows setup-via Bluetooth (Driver)

Please take a short time to watch the video, which will guide you through the setup process step by step.

STEP 1: Driver Installation

NOTE:

■ It is recommended to close security software before installation to avoid preventing installation.

■ Bluetooth is available within 5 meters distance, so make sure your computer and printer are as close as possible. 

• Before installation, ensure the printer is turned on. 
• Copy the Windows driver from the U-disk or download it from this link:https://support.pedoolo.com/a/solutions/articles/151000077768
• Open and install it.

Select ‘Install the printer driver’-> ‘Next’

Select ‘Bluetooth’-> ‘Next’, and you need to wait for a while for searching.

 Select Bluetooth printer model ‘BY-482BT_xxxx’-> ‘Next’

Select Printer driver model ‘BY-482BT’-> ‘Next’

Input ‘Printer name’, select ‘Use the printer as default’-> ‘Next’

Click on ‘Print Test Page’ to check if the printer has been set up successfully.

Now the printer driver is installed successfully.

STEP 2: Printer Preference Setting

Go to ‘Settings’-> ‘Devices’-> ‘Printers & Scanners’, find the printer ‘BY-482BT’, click ‘Manage’->‘Printing preferences’

(1)Paper size 

Choose the corresponding paper size according to the label size. (Generally, most shipping labels are 4”x6”.)

If you can’t find your needed size, choose ‘CUSTOM’ and add your customized size. 

(2)Print speed and density 

Click ‘Parameters’, and you can reset the new print speed and density. (Generally, just keep these default speed and density settings to print.)

NOTE: If the labels printed are light or not clear, you can increase the density properly. But too high density may cause some unwanted dark lines, and the label may get too hot and stick to the printer head.

(3)Print a sample label 

Open a PDF file-> Click ‘Print’ (You can copy the sample label file from the U-disk to test.)

Select the Printer ‘BY-482BT’-> Click ‘Properties’ to check the setting ‘Paper size’, ‘Print speed’, and ‘Print density’

If the preview looks good, then click ‘Print’.

NOTE: 

■  Before printing, please make sure the size of the thermal labels you load is the same as the size settings on devices. 

■  If you want to print a Word file, please transfer it to a PDF file and then print it to get the best out of print.